Gear Position Sensor Inspection (Gps: Gear Position Sensor) (Te-Txc) - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
3
Workshop Manual Ed. 12-2011
ELECTRICAL SYSTEM
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA

Gear position sensor inspection (GPS: Gear Position Sensor) (TE-TXC)

Set the meter to the "Ohm" scale and disconnect the six-way connector (1) of the
alternator from the main wiring harness (the gear sensor wiring is secured to the
alternator wiring with a clip). Touch one meter probe to engine ground and insert
the other probe into the connector hole for the WHITE/BLACK gear sensor wire
(2). The lever (3) is placed on the left-hand side of the engine. After each gear
shift, it automatically returns to the horizontal position. First gear is engaged by
pushing the lever downwards; for other gears push it upwards. Check the read-
ings provided in the relevant table.
TE - TXC
A
B
C
D
E
F
G
H02362
NOTE: The TC version does not have the gear sensor as the control
unit does not need this type of signal.
M.28
NEUTRAL
1st
2nd
3rd
4th
5th
6th
312-319
725-739
1,31-1,34
2.18-2.23 K
3.61-3.68 K
6.58-6.71 K
15.2-15.5 K