Starter Motor Idle Gear Removal/Installation; Installation Of The Flywheel With Freewheel Control Gear - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
1
4
2
5
1
3
GENERAL ENGINE PROCEDURES

Starter motor idle gear removal/installation

- Remove the washer (1) and bushing (2).
- Remove the dual gearbox (4).
- Remove the idle gear (3).
3
H11539
- Remove the freewheel gear (5)
- Reassemble all parts, in the reverse order compared to disassembly.
H11540

Installation of the flywheel with freewheel control gear

- Clean the collar and internal bearing of the freewheel gear and lubricate with
engine oil.
- Clean the cone of the crankshaft and of the flywheel.
2
- Apply a thin layer of Loctite 648 on the crankshaft cone.
Pay attention that the freewheel bearing does not come into contact
with the Loctite.
- Fit the flywheel (1) onto the crankshaft, making sure that the groove and the
key are aligned and that the freewheel is set on the relevant gear
H11543
- Clean the threading on the crankshaft.
- Insert the washer (2) and replace the nut (3) with a pre-lubricated nut and
tighten to torque.
- Refit the right crankcase as indicated in the relevant paragraph.
F1.11
Workshop Manual Ed.09-2012