Mitsubishi 1989-1993 GALANT Service Manual page 1076

ACTIVE-ELECTRONIC CONTROL SUSPENSION - Height Sensor
From 1990 models
Good
I
center
Bolt
SERVICE POINTS OF INSTALLATION
7. INSTALLATION OF REAR ROD ASSEMBLY / 3. FRONT
ROD ASSEMBLY
(1) Adjust the front and rear height sensors so that
Bad
(2) When installing the rear rod assembly, install the rear
left edge
surface
dimension A of the rod in the illustration is within
specification.
Rod assembly length (A)
Front
Rear
Caution
1. When adjusting the length of the rod, adjust so
that dimension B is uniform
2. Height sensors must be installed so that the ball
joint at the rod end is at rocking centre.
height sensor brackets so that the dimension L in the
illustration. is the standard value.
Standard value (L): 314-316 mm (12.3-12.4 in.)
254-255 mm (9.9-10.0 in.)