Mitsubishi 1989-1993 GALANT Service Manual page 1097

R E A R S U S P E N S I O N <FWD> - Torsion Axle and Arm Assemblv
TSB Revision
SERVICE POINTS OF REMOVAL
12. REMOVAL OF SHOCK ABSORBER LOWER MOUNTING
BOLT/ 13. TRAILING
14. TORSION AXLE AND ARM ASSEMBLY
raise it slightly.
Caution
1. Always insert a wooden block between the jack
receptacle and the axle beam and place the jack
at the center of the axle beam.
2. Be sure that the jack does not contact the lateral
rod.
trailing arm mounting bolt.
(3) Lower the jack slowly, and then remove the torsion
axle and arm assembly.
INSPECTION
Check the trailing arm and axle beam for deformation or
l
damage.
Check the bushings for cracking, deterioration, or unusual
l
wear.
NOTE
For information concerning the replacement of the trailing
arm bushing, refer to P.34-8.
MOUNTING
ARM
BOLT