Brake Pedal Inspection - Mitsubishi 1989-1993 GALANT Service Manual

No continuity
<Vehicles with auto-cruise
control system>
SERVICE BRAKES
INSPECTION
Check the bushing for wear.
l
Check the brake pedal for bend or twisting.
l
Check the brake pedal return spring for damage.
l
STOP LIGHT SWITCH
Connect a circuit tester to the stop light switch, and check
whether or not there is continuity when the plunger of the stop
light switch is pushed in and when it is released.
The stop light switch is in good condition if there is no
Continuity
continuity when the plunger is pushed in to a depth of within 4
mm (.16 in.) from the outer case edge surface, and if there is
continuity when it is released.
For vehicles with the auto-cruise control system, the check for
m m (.16 in.)
continuity should be made at connectors "a" and "b" of the
stop light switch.
SERVICE POINTS OF INSTALLATION
7. INSTALLATION OF RETURN SPRING
Install the return spring in the direction indicated in the
illustration.
TSB Revision