Rear Suspension Assembly Lubrication Points - Mitsubishi 1989-1993 GALANT Service Manual

REAR SUSPENSION
Lubrication points
SERVICE POINTS OF REMOVAL
11. REMOVAL OF LATERAL ROD MOUNTING BOLT
(1) Remove the lateral rod mounting bolt.
(2) Secure and hold the lateral rod to the axle beam with
wire, etc.
13. REMOVAL OF SHOCK ABSORBER UPPER MOUNTING
NUT/ 14. TRAILING ARM MOUNTING BOLT/ 15. REAR
SUSPENSION ASSEMBLY
(1) Jack up the torsion axle and arm assembly in order to
raise it slightly.
Caution
1. Always insert a wooden block between the jack
receptacle and the axle beam and place the jack
at the centre of the axle beam.
2. Make sure that the jack does not contact the
lateral rod.
(2) Remove the shock absorber mounting nut and trailing
arm mounting bolt.
(3) Lower the jack slowly, and then remove the rear
suspension assembly.
INSPECTION
l Check the trailing arm and axle beam for deformation or
damage.
Check the lateral rod for damage or deformation.
l
Check the bushings for cracking, deterioration, or unusual
wear.
TSB Revision