Mitsubishi 1989-1993 GALANT Service Manual page 1048

ACTIVE-ELECTRONIC CONTROL SUSPENSION
TSB Revision
(3) Use vinyl tape to tape the stabilizer link where shown in
the illustration, and then install the dust cover to the
stabilizer link.
Secure
(4) the dust cover by the clip link.
SERVICE POINTS OF INSTALLAION
10. INSTALLATION OF STABILIZER BAR BRACKET
(1) Provisionally tighten the stabilizer bar bracket.
(2) Align the bushing end with the marked part of the
stabilizer bar, and then fully tighten the stabilizer bar
bracket.
(3) Provisionally tighten the removed lower arm installation
part to the crossmember.
Caution
Make the final tightening with the vehicle in the
unladen condition; the tightening should be at the
specified tightening torque.
7. INSTALLATION OF STABILIZER LINK MOUNTING
NUTS
Using a wrench or similar tool to secure the ball studs at
both ends of the stabilizer link, tighten the mounting nuts.
I