Mitsubishi 1989-1993 GALANT Service Manual page 1094

REAR SUSPENSION <FWD>
TSB Revision
SERVICE POINTS OF REASSEMBLY
11. INSTALLATION OF COIL SPRING
(1) Use the special tool
coil spring and insert it in the shock absorber.
(2) Align the edge of the coil spring to the position of the
shock absorber spring seat as shown.
9. INSTALLATION OF DUST COVEl?/8. CUP ASSEMBLY
As shown in the illustration, fit the dust cover to the cup
assembly.
4. INSTALLATION OF BRACKET ASSEMBLY/l. PISTON
ROD TIGHTENING NUT
(1) With the position of the bracket assembly as shown in
the figure, tighten the tightening nut to the specified
torque.
(2) Install the coil spring so that the lower edge fits into the
spring seat groove and the upper edge fits into the
spring pad groove, then remove the special tool
to compress the