Installation Of Rear Speed Sensor - Mitsubishi 1989-1993 GALANT Service Manual

Left side view
Right side
Left side view
Left side
(1) Temporarily install the speed sensor to the rear axle
spindle.
Caution
Be careful when handling the pole
the speed sensor and the toothed edge of the rotor
so as not to damage them by striking against metal
objects.
sensor cable, and secure the cable by the clip.
(shaded in the illustration) of the speed sensor
cable is not twisted.
illustration) so that the trailing arm and speed
sensor cable do not contact, and then secure by
the clip.
Caution
Because there is the possibiliti of damage to the
cable during driving if the speed sensor cable and
the trailing arm come into contact, or if the speed
sensor cable is twisted, care must be taken regard-
ing this point.
(3) Inset-t a feeler gauge into the space between the
speed sensor's pole piece and the rotor's toothed
surface, and then tighten the speed sensors at the
position where the clearance is the standard value.
Standard value: 0.3-0.9 mm (.012--035 in.)
NOTE
Check to be sure that there is no contact of the speed
sensor's pole piece and the rotor's toothed surface
when the rear hub assemlby is slowly rotated one
time.
If there is contact, it is probable that the rotor or the
rear hub is installed incorrectly, recheck installation.
Install the rear speed sensors as shown in the illustration.
Cross-section A-A
Rear speed
sensor
Cross-section B-B
TSB Revision
OF REAR SPEED SENSOR <MID>
piece at the tip of
REAR SPEED SENSOR <AWD>
Parking
cable
Cross-section C-C
Rear speed
sensor