Mitsubishi 1989-1993 GALANT Service Manual page 1078

ACTIVE-ELECTRONIC CONTROL SUSPENSION
Steering wheel angular-
velocity sensor
- -
SERVICE POINTS OF REMOVAL
1. REMOVAL OF THROTTLE POSITION SENSOR
Disconnect the harness connector, then remove the
throttle position sensor from the throttle body.
2. REMOVAL OF STEERING WHEEL ANGULAR-VELOCITY
SENSOR
Remove the pin terminal from the column switch connec-
tor, then remove the steering wheel angular-velocity
sensor from the column switch.
Caution
1. The steering wheel angular-velocity sensor utilizes a
photo coupler and care should be paid to ensure
that no dust or grease are allowed to come into
contact with it.
2. Be careful and ensure that the column switch side
slit panel is not bent nor oil allowed to come into
contact with it.
3. REMOVAL OF G SENSOR
Disconnect the connection of the harness connector, and
then remove the G sensor.
C a u t i o n
W h e n r e m o v i n g t h e G sensor, take care not to drop it or
subject it to severe impact.
INSPECTION
For information concerning the procedures for checking each
sensor, refer to the service adjustment procedures section
and to the troubleshooting guide.
TSB Revision
- Sensor
ACTIVE ECS