Reserve Tank Disassembly And Reassembly - Mitsubishi 1989-1993 GALANT Service Manual

ACTIVE-ELECTRONIC CONTROL SUSPENSION - Reserve Tank
Splash
shield
Grommet
DISASSEMBLY AND REASSEMBLY
Disassembly steps
l a
1. Air tubes
2. Joint assembly
3. O-ring
4. Wiring harness
(incorporated with
high pressure switch)
5. O-ring
6. Low pressure switch
7. O-ring
8. Reserve tank
(3) Install the splash shield's installation clips and the bolt.
Note that the installation clips should be installed by
the procedures described below.
in the splash shield.
surface of the grommet.
fixed.
5. INSTALLATION OF AIR TUBES
Push the air tube' inward to the joint assembly at the
device side until a "click" is heard, and then check to be
sure that the tabs of the joint assembly are securely
affixed to the air tube.
6 - 7 ft.lbs.
TSB Revision
'6
I