Rear Wheel Alignment Inspection - Mitsubishi 1989-1993 GALANT Service Manual

REAR SUSPENSION <AWD> - Service Adjustment Procedures
SERVICE ADJUSTMENT. PROCEDURES
REAR WHEEL ALIGNMENT INSPECTION mm
The rear suspension assembly must be free of worn, loosen or
damaged parts prior to measurement of wheel alignment.
TOE-IN
(1) Measure the toe-in with a toe-in gauge.
Standard value: 3+3 mm (.12+.12 in.)
(2) If the toe-in is not within the standard value, adjust it by
moving the mounting bolts located on the crossmember
side of the trailing arm.
NOTE
Make the adjustment by moving the left and the right bolts
equally.
Movement of one division on the scale will cause toe-in
variation of about 2 mm (.08 in.).
CAMBER
(1) Measure the camber with a camber/caster/kingpin gauge.
Standard value: -1"OO'f30'
(2) If the camber is not within the standard value, adjust it by
moving the mounting bolt located on the crossmember
side of the upper arm.
NOTE
Movement of one division on the scale will
variation of about 15'.
Caution
1. As toe-in will vary 0.9 mm LO35 in.) for every
camber scale adjustment, adjust the toe after
adjusting camber.
2. The difference between the left and the right
camber shall be less than 15'.
cause camber