Mitsubishi 1989-1993 GALANT Service Manual page 1113

REAR SUSPENSION <AWD> - Trailina Arm
SERVICE POINTS OF REMOVAL
2. REMOVAL OF REAR BRAKE ASSEMBLY
Remove the rear brake assembly installation bolts, then
suspend the rear brake assembly from the vehicle with
wire, etc.
5. REMOVAL OF SELF LOCKING NUT
With the special tool, secure the rear axle shaft, then
remove the self locking nut.
9. REMOVAL OF REAR AXLE SHAFT
With the special tool, remove the rear axle shaft.
11. REMOVAL OF SELF LOCKING NUT (UPPER ARM)
With the special tool, disconnect the upper arm ball joint
and knuckle.
Caution
While the special tool is being used, do not remove the
self locking nut; only loosen it.
12. REMOVAL OF SELF LOCKING NUT (LOWER ARM)
With the special tool, disconnect the lower arm ball joint
and knuckle.
Caution
While the special tool is being used, do not remove the
self locking nut; only loosen it.
TSB Revision