Tyre Pressure Monitoring System (Tpms) - Mitsubishi Outlander PHEV 2019 Manual

Tyre pressure monitoring system (TPMS)

CAUTION
• When the vehicle is leaning much to one
side due to heavy luggage on it or improp-
erly adjusted tyre pressures.
• When oncoming vehicles' headlamps
shine the sensor.
• When the vehicle is equipped with non-
standard tyres (including excessively
worn tyres), is using a snow traction de-
vice (tyre chains), or has non-specified
components such as a modified suspen-
7 sion.
• When the windscreen is covered with wa-
ter droplets, snow, dust, etc.
l Follow the instructions given below to keep
your LDW in good operating conditions.
• Always keep the windscreen clean.
• Avoid applying a strong shock or pressure
to the sensor. Do not attempt to detach or
disassemble it.
• Do not put anything like a sticker on the
area in front of the sensor lens of the
windscreen.
• Use only MITSUBISHI MOTORS GEN-
UINE Parts when replacing the wind-
screen wipers.
7-92 Starting and driving
Tyre pressure monitoring
system (TPMS)
E00637100282
The tyre pressure monitoring system (TPMS)
uses tyre inflation pressure sensors (A) on the
wheels to monitor the tyre inflation pressures.
The system only indicates when a tyre is sig-
nificantly under-inflated.
The base tyre pressure can be set at desired
value by the driver with the reset function ex-
ecution. (The low pressure warning threshold
is set based on the reset.)
The tyre inflation pressure sensor IDs for two
sets of tyres can be registered by a
MITSUBISHI MOTORS Authorized Service
Point, and the valid ID set can be switched by
the Multi-information display switch (It's
beneficial in case of seasonal tyre change be-
tween summer tyre and winter tyre.)
OGGE19E1
NOTE
l The tyre pressure monitoring system
(TPMS) is not a substitute for regularly
checking tyre inflation pressures.
Be sure to check the tyre inflation pressures
as described in "Tyres" on page 11-10.
l The tyre inflation pressure sensor (B) is in-
stalled in the illustrated location.
• On vehicles with the type 1 sensor which
has the metallic air valve (C), replace
grommet and washer (D) with the new
ones when the tyre is replaced.
• On vehicles with the type 2 sensor which
has the rubber air valve (E), replace the
rubber air valve (E) with the new one
when the tyre is replaced.
For details, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.