Mitsubishi 1989-1993 GALANT Service Manual page 1214

Brake hose
<Up to 1991 models>
1
<From 1992 models>
SERVICE BRAKES - Brake Line
SERVICE POINTS OF REMOVAL
1. REMOVAL OF FRONT BRAKE HOSE/22. REAR BRAKE
(1) Holding the lock nut on the brake hose side, loosen
the flared brake line nut.
(2) Pull off the brake hose clip and remove the brake hose
from the bracket.
19. REMOVAL OF PROPORTIONING VALVE/24. DELAY
VALVE
Do not disassemble the proportioning valve and delay
valve because its performance depends on the set load of
the spring.
INSPECTION
Check the brake tubes for cracks, crimps and corrosion.
l
Check the brake hoses for cracks, damage and leakage.
l
Check the flared brake line nuts for damage and leakage.
SERVICE POINTS OF INSTALLATION
UNIT
Connect the tubes and hoses to the hydraulic unit as
shown in the illustration.
NOTE
Connect each tube to the hydraulic unit in accordance
with the identification colour codes.
2 5
4
1.
From the hydraulic unit to the front
2.
From the hydraulic unit to the rear
3.
From the hydraulic unit to the front
4.
From the hydraulic unit to the rear
5.
From the master cylinder
(for left front and right rear)
6.
From the master cylinder
(for riaht front and left rear)
brake
brake
brake
brake