ACTIVE-ELECTRONIC CONTROL SUSPENSION - Lower Arm
TSB Revision
SERVICE POINTS OF REMOVAL
1. REMOVAL OF FRONT HEIGHT SENSOR ROD
When removing the right strut assembly and knuckle
union, always first remove the lower arm'and front height
sensor rod union.
Use wrench or similar tool to secure the ball stud part at
both ends of the stabilizer link, and then remove the nut.
5. REMOVAL OF LOWER ARM BALL JOINT
Using the special tool, disconnect the lower arm ball joint
from the knuckle.
NOTE
part.
(2) Loosen the nut but do not remove it.
INSPECTION
Check the lower arm for bend or breakage.
l
Check the clamp for deterioration or damage.
l
Check the bushing for wear and deterioration.
l
Check the ball joint dust cover for cracks.
l
Check all bolts for condition and straightness.
l