Trailing Arm Bushing Replacement - Mitsubishi 1989-1993 GALANT Service Manual

ACTIVE-ELECTRONIC CONTROL SUSPENSION
Base
, ,
surface
Base
ace
CROSS SECT. A-A
Chamfered side
Lateral rod
mounting bolt
Axle beam
I II
(1) Drive out and press in the arm bushing using the special
tool.
Caution
Mount the bearing of the special tool so that the race
surface faces toward the nut.
Arbor
(2) Press in the bushing from the chamfered side onto the
trailing arm so that the hole is in position as shown.
(3) Press in the bushing so that the amount of projection is
uniform throughout.
SERVICE POINTS OF INSTALLATION
12. INSTALLATION OF LATERAL ROD MOUNTING BOLT
Install the lateral rod mounting bolt from the direction
shown in the illustration.
6. INSTALLATION OF THE FLANGE NUT
After tightening the flange nut, align with the indentation
in the spindle, and crimp.
TSB Revision
Torsion Axle and