NEC Univerge SV8100 Features And Specifications Manual page 1481

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-12-58 Service Code Setup (for Service
Access) – Transfer into
Conference
11-15-09 Service Code Setup
Administrative (for Special
Access) – Transfer to Incoming
Ring Group
15-02-05 Multiline Telephone Basic Data
Setup – Transfer Key Operation
Mode
15-02-24 Multiline Telephone Basic Data
Setup – Conference Key Mode
Transfer
Description/Comments
Assign the code a user dials to
Transfer a call into a Conference
call. This code is normally 624.
When a call is transferred using
this service code, it is transferred
to the ring group destination for
that incoming trunk. For example,
trunk 2 is in Ring Group 4. When
the call is transferred using this
service code, the trunk rings all
extensions programmed for Ring
Group 4 or ring the External
Paging Group for Ring Group 4,
depending on how the system is
programmed.
Set the operating mode of the
extension Conf key. The keys can
be for Call Transfer, Serial Calling
or Flash. When selecting 2, refer
also to Program 81-01-14.
Program an extension Conf key
for Conference or Transfer. When
set for Transfer, the user places a
call on hold, dials the extension to
which it should be transferred,
then presses Conf. The call is then
transferred. When set for
Conference, with an active call,
the user can press Conf, place a
second call, then press Conf
twice. All the calls are then
connected.
Assigned Data
1
MLT, SLT
(default = 624)
(default not assigned)
0 = Transfer
1 = Call back
2 = Hook
(default = 0)
0 = Conference
1 = Transfer
(Default = 0)
Issue 8.01
Level
2 3




2 - 1453