Sip Trunk Registration (Not Required); Calling Party Information (Trunk); Figure 11 Sip Trunk Registration Information - NEC UNIVERGE SV8100 Configuration Manual

Windstream
3.8
3.9
SIP Trunking Service Configuration Guide

SIP Trunk Registration (Not Required)

Figure 11 SIP Trunk Registration Information

Calling Party Information (Trunk)

Caller ID - In the Invite message there are two fields that can have caller ID. One
field is the "SIP From Address" and the other field is "SIP Display Info". If both of
these fields are left blank the call will not complete.
Below is an example of a SIP Invite Message with outbound CID.
From "2142622000"<sip:test@172.16.0.100>
10-28-04 : SIP System Information Setup – User ID
This is the default "Display Info" and "From Address" if either of these fields is
blank, what is assigned in this command will be inserted. This setting has the
lowest priority, if any of the next commands are set they will be sent out instead of
this command.
14-12-01 : SIP Register ID Setup for IP Trunk – Register ID
On a per trunk basis, you can choose a SIP register ID of 0~31. If the ID is left to
0, the "SIP from Address" would not be assigned on a per trunk basis. If set to
1~31 it then looks at command 10-36-02 to populate the "SIP from Address" field.
14-12-02 : SIP Register ID Setup for IP Trunk – Pilot Register ID
This is for SIP trunks to the provider for inbound purposes. If 10-28-06 (Trunk port
Binding) is enabled, inbound calls map to the trunk. If you want to create a hunt
group when trunk port binding is enabled, set multiple trunks to the same pilot and
then define that number in 10-36.
Issue 1.0
17