NEC Univerge SV8100 Features And Specifications Manual page 358

Hide thumbs Also See for Univerge SV8100:

Table of Contents

The following steps are not available for DISA or Tie Line trunks:

Dial the extension number of the internal party.

Dial the single digit service code, if programmed.

Instead of the single digit service code, the service code 710 can also be dialed at this point.

To Transfer a Call into a Conference:

While on a call, press Hold.

Dial the Transfer to Conference service code (default = 624).

If the telephone does not have the proper COS, a warning tone is sent. After the user hangs up, the system

automatically places a Callback to the extension.

The display shows the line Number, Number/Name and Extension Name/Number.

Dial the extension number or press a DSS key of a telephone in a Conference call.

If an error tone is heard, Barge-In is not enabled for the extension and the call cannot go through. Retrieve the

call by pressing the flashing line or Call Appearance (CAP) Key or hang up and the call recalls the extension.

When the call is transferred into the Conference, an intrusion tone is heard by all parties in the conference,

depending on the entries in Program 20-13-17 and Program 80-01, and all display multiline terminals show the

joined party.

To cancel the transfer, press the flashing line or Call Appearance (CAP) Key to retrieve the call.

UNIVERGE SV8100