Consumable/Routine Maintenance Errors; Replace Fuser Or Fuser Life Error - Xerox Phaser 6128MFP Service Manual

Error Messages and Codes

Consumable/Routine Maintenance Errors

Replace Fuser or Fuser Life Error

Applicable Errors
Initial Action
3-54
Warning
Allow the Fuser to cool before removal.
The Fuser has reached end of life. This troubleshooting procedure applies to this
error.
• Fuser Life
• 010-351: Replace Fuser
• Check the Fuser life counter. If the count is at or near end of life, replace the
Fuser.
• Cycle printer power.
• If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL6.1.1
MCU Board, PL10.7.7
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Fuser life count.
Has the count reached end of life?
2 Is the Fuser correctly installed?
3 Cycle system power.
Does the error persist.
4 Replace the Fuser (page 8-11).
Does the error still occur?
Wiring and Plug/Jack Map References
"Map 4 - Imaging" on page 10-9
"Fuser" on page 10-21
Yes
Replace the
Fuser
(page 8-11).
Go to step 3. Reseat the
Go to step 4. Complete.
Replace the
MCU Board
(page 8-57).
Phaser 6128MFP Service Manual
No
Go to step 2.
Fuser.
Complete.