Exit Off Jam/Exit Off Early Jam
Phaser 6000/6010 and WC 6015 MFP
The paper passed through the Exit Sensor earlier than the specified time, or did
not pass through the Exit Sensor within the specified time.
Applicable Error
•
077-108: Exit Off Jam
•
077-109: Exit Off Early Jam
Initial Actions
•
Check the media path for obstructions or debris.
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL5.1.1
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check P/J18 on the MCU Board.
Is P/J18 connected securely.
2
Does the error persist?
3
Replace the Fuser (page 8-80).
Warning: Allow the fuser to cool
Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Fuser" on
page 10-17
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Fuser" on
page 10-31
before replacement.
Error Messages and Codes
Yes
No
Go to step 3.
Reconnect
P/J18, then go
to step 2.
Go to step 3.
Complete.
Replace the
Complete.
MCU Board
(page 8-121).
3-89