Side Stand Switch Removal/Installation - Honda VT600C Shadow VLX Service Manual

After '93 :
Remove the left side cover.
Disconnect the side stand 3 P g reen connector and check for
conti n u ity between each terminals as shown below.
There should be continuity between the
conti n u ity chart.
G reen/White Yellow/ B lack
Side sta n d
down
Side stan d
u p
R E M OVAL/ I N STA L LATI O N
Remove t h e left side cover.
Discon nect the side stand 3 P g reen connector.
Remove the side stand switch mounting bolt,setting plate,
washer a n d side stand switch.
I nstall the switch in the reverse order of removal.
N OTE
Align the switch pin with the side stan d h ole.Aiign the
•
switch g ro ove with the setting plate tang and align the
setting plate solt with the side stand return spring holding
pin.
TO R Q U E :
Side stand switch mounting bolt : 9 N · m (0 . 9 kg-m , 7 ft-lb)
R oute the side stand switch wire properly.
I G N ITION TI M I NG
NOTE
The ignition control module system is factory pre-set and
can not be adjusted.lgnition tim i n g inspectio n procedures
a re g iven to inspect the fu nction of the ignition control
module com ponents.
Con nect the timing light to the other spark plug wire if you
•
see that the ignition timing is i ncorrect,and you might be
able to see the timing is correct.
Warm up the engine to operating temperature.
Remove the timing inspection hole cap on the right crankcase
cover.
Connect the timing light to the front spark plug wire.
0-0
positions on the
G reen
r
I G N IT I O N S Y ST E M
( 1 ) D OWN
( 1 ) B O LT
1 6-7