Honda Civic Service Manual page 652

ABS Gomponents
ABS Modulator-Control Unit Removal and Installation {cont'dl
3. Disconnectthe six brake lines.
4. Remove the two I mm nuts.
5. Remove the ABS modulator-control unit (C).
Installation
' 1 .
I n s t a l l t h e A B S m o d u l a t o r c o n t r o l u n i t , t h e n t i g h t e n t h e t w o 8 m m n u t s .
2. Align the connecting surface ofthe ABS control unit 3'lP connector.
3 . P u s h i n t h e l o c k o f t h e A B S c o n t r o l u n i t 3 1 P c o n n e c t o r u n t i l y o u h e a r i t c l i c k i n t o p l a c e . t h e n c o n n e c t t h e c o n n e c t o r .
4. Connect the six brake Iines.
5. Bleed the brake system, starting with the front wheels.
6. Connect the PGM Tester, and do the solenoid function test for each wheel.
7. Bleed the brake system again, staning with the front wheels.
8. Start the engine, and check that the ABS indicator and brake system indicator go off.
9. Disconnect the Honda PGM Tester. Test-drive the vehicle, and check that the ABS indicator and brake qvqtem
i n d i c a t o r d o n o t c o m e o n .
19-58