Honda Civic Service Manual page 480

Fit the boot ends onto the driveshaft and the
inboard joint, then install the new double loop band
{A) onto the boot.
P u l l u p t h e s l a c k i n t h e b a n d b y h a n d
M a r k a p o s i t i o n ( A ) o n t h e b a n d 1 0 - 1 4 m m ( 0 . 4 -
0 . 6 i n . ) f r o m t h e c l i p { B ) .
15. Thread the free end ofthe band through the nose
section of the commercially available boot band
tool KD-3191 or equivalent (A), and into the slot on
t h e w i n d i n g m a n d r e l ( B ) .
Place a wrench on the winding mandrel of the boot
band tool, and tighten the band until the marked
spot (C) on the band meets the edge of the clip
L i f t u D t h e b o o t b a n d t o o l t o b e n d t h e f r e e e n d o f
the band 90 degrees to the clip. Center-punch the
c l i o , t h e n f o l d o v e r t h e r e m a i n i n g t a i l o n t o t h e c l i p .
1 6 .
1 7 .
(cont'd)
1 6 - 1 3