Honda Civic Service Manual page 570

Front Suspension
Knuckle/Hub/Wheel Bearing Replacement {cont'dl
Special Tools Required
. Hub dis/assembly tool 07GAF-SE00100
. Balljoint remover,2S mm 0TlvlAC-S100200
. Attachment 62 x 68 mm 07746-0010500
. Driver 07749-0010000
. SuDDort base 07965-5D90'100
1. Raise the front of the vehicle, and support it with
safety stands in the proper location (see page 1-8).
2. Remove the wheel cap, wheel nuts, and front wheel.
3. Remove the brake hose bracket mounting bolt (A).
1 0 8 N . m
(11.0 kgf m,
80 rbf.ftl
A
8 x 1.25 mm
22N.m
12.2ksl.m,
26 tbf.ftl
B
12 x 1.25 mm
108 N.m
{11.0 kgf.m,
80 rbf.ftl
4 . Remove the caliper bracket mounting bolts (B), and
remove the caliper assembly (C) from the knuckle.
To prevent damage to the caliper assembly or
brake hose, use a short piece of wire to hang the
caliper assembly from the undercarriage. Do not
twist the brake hose with force.
18-12
5. Raise the stake (A), and remove the spindle nut (B).
- B
'
2 2 x 1 . 5 m m
,
1 8 1 N . m
('18.s kgf.m,
134 tbt.ft)
6. Remove the brake disc retaining flat screws (A).
A
6 x 1 . 0 m m
9.8 N.m
{1.0 kgt.m,
7.2 tbl.ttl
7. Screw two 8 x 1.25 mm bolts (B) into the disc to
oush it awav from the hub. Turn each bolt two turns
at a time to prevent cocking the disc excessively,
\
\