Honda Civic Service Manual page 681

12. Glue the side upper fasteners (A) andsidelower
fasteners (B) with adhesive tape (3M 5312, or
equivalent)to the hatch as shown.
Fastoner Locations
A>: Fastener, 2 B >: Fastener, 2
T-8.
cl
a r \ \
i t f ,
t 5 .
Set the rear window in the opening, and center it.
Align the clips (A) of the rear window with the holes
i n t h e o p e n i n g f l a n g e . M a k e a l i g n m e n t m a r k s ( B )
across the rear window, hatch, and body with a
grease pencil at the four points shown. Be careful
not to touch the rear window where adhesive will
b e a p p l i e d .
1 4 . R e m o v e t h e r e a r w i n d o w .
1 5 . W i t h a s p o n g e , a p p l y a l i g h t c o a t o f g l a s s p r i m e r
along the edge of the rear window (A), upper
rubber dams (B), and lower rubber dam (C) as
shown, then lightly wipe it off with gauze or
cheesecloth:
. With the printed dots (D) on the rear window as a
guide, apply the glass primer to both side
portions of the rear window.
. Do not apply body primer to the rear window,
and do not get hatch and glass primer sponges
m i x e d u p .
. Never touch the primed surfaces with your hands.
lf you do, the adhesive may not bond to the rear
window properly. causing a leak after the rear
w i n d o w i s i n s t a l l e d .
. Keep water, dust, and abrasive materials away
from the primed surface.
..
: Apply glass piimer here.
( c o n t ' d )
20-27