Honda Civic Service Manual page 686

Glass
Ouarter Glass Replacement (cont'dl
First glue the front seal (A) with adhesive tape {31\4
4 2 1 3 , o r e q u i v a l e n t ) . a n d g l u e t h e r u b b e r d a m ( B )
with adhesive tape (NITTO 501M, or equivalent) to
the inslde face of the quarter glass (C) as shown.
Before installing the front seal and rubber dam,
a p p l y p r i m e r ( 3 M N - 2 0 0 , o r e q u i v a l e n t ) t o t h e i n s i d e
tace of the glass. then glue the seal on:
. Be sure the front seal lines upwiththe bottom
and front edges of the glass.
. Be careful not to touch the glass where adhesive
w i l l b e a o o l i e d .
.,1.,,/:/ | Apply prlJner hete.
-"-c
i--l
'100 mm
{3.9i1in.)
45 mm
{ 1 . 7 7 i n . }
3.5 mm
{0.r4 in.l
30 mm
1 1 . 1 8 i n . l
50 mm
I
{ 1 . 9 7 i n . 1 /
\ t
6 mm (0.24 in.)
n L
v - -
20-32
'13.
With a sponge, apply a light coat of glass primer
along the edge of the rubber dam (A) and front seal
(B) as shown, then lightly wipe it off with gauze or
cheesecloth:
With the printed dots (C) on the quarter glass (D)
as a guide, apply the glass primer to the upper
and lower corner ponions of the quarter glass.
Do not apply body primer to the quaner glass,
and do not get body and glass primer sponges
m r x e d u p .
Never touch the primed surfaces with your hands.
lf you do, the adhesive may not bond to the
quarter glass properly, causing a leak after the
quarter glass is inslalled.
Keep water, dust, and abrasive materials away
from the primed surface.
1 1 m m
lo.i(} in.)