Honda Civic Service Manual page 571

8. Remove the flange bolt {A) andwheel sensor(B)
from the knuckle. Do not disconnect the wheel
sensor conneclor.
Remove the flange nut (A) while holding the joint
pin (B) with a hex wrench (C), and disconnect the
s t a b i l i z e r l i n k { D ) f r o m t h e l o w e r a r m ( E ) .
A
5 x 1 . 0 m m
9.8 N.m
(1.0 kgl.m,
7.2 tbt.ftl
9 .
10 x 1.25 mm
39 N.m (,1.0 kgf.m,29lbf.ft)
10. Remove the lock pin (A)from the lower arm ball
joint, and remove the castle nut (B).
NOTE: During installation, insert the lock pin into
t h e b a l l j o i n t p i n f r o m t h e l n s i d e t o t h e o u t s i d e o f
the vehicle. The closed end of the lock Din must be
i n t h e r a n g e s h o w n .
07 MAC-SL00200
€--....-"
12 x 1.25 mm
59 69N m
'R.
1 1 .
12.
(6.0 7.0 kgl m,
43 -51 lbf tt)
Disconnect the lower arm from the knuckle using
the special tool (see page l8-10).
Loosen the damper pinch bolts (A) while holding
the nuts (B), and remove the bolts and nuts.
'13. Remove the driveshaft outboard joint
{C) fromthe
knuckle (D) by tapping the driveshaft end (E) with a
plastic hammer while drawing the knuckle outward,
then remove the knuckle.
NOTE: Do not Dull the driveshaft end outward. The
driveshaft joint may come off.
( c o n t ' d )
1 8 - 1 3