Honda Civic Service Manual page 502

Steering
Steering Column Removal
lnstallation
1 .
4 .
I n s t a l l t h e s t e e r i n g c o l u m n , a n d m a k e s u r e t h e
wires are not caught or pinched by any parts.
Insertthe upper end ofthe steering joint onto the
steering shaft {A) (line up the bolt hole (B) with the
flat portion (C) on the shaft).
8 x 1 , 2 5 m m
28 N.m
{2.9 kgf m,
21 rbr.ft)
A
Slip the lower end of the steering joint onto the
pinion shaft {D) (line up the bolt hole with the
g r o o v e ( E ) a r o u n d t h e s h a f t ) , a n d l o o s e l y l n s t a l l t h e
lower joint bolt. Be sure that the lower joint bolt is
securely in the groove in the pinion shaft.
Pull on the steering joint to make su re that the
s t e e r i n g j o i n t i s f u l l y s e a t e d . T h e n i n s t a l l t h e u p p e r
joint bolt, and tighten it to the specified torque.
Tighten the lower joint bolt to the specified torque.
Finish the installation, and note these items:
. Make sure the wire harness is routed and
fastened properly.
. Make sure the connectors are properly connected.
. R e i n s t a l l t h e s t e e r i n g w h e e l ( s e e p a g e 1 7 - 8 ) .
. Reconnect the battery.
- Do the power window control unitreset
procedure {see page 22-128).
- Enter the anti-theft code for the radio, then
enter the custmer's radio station presets.
- Set the clock.
. Verify horn, turn signal switch, and cruise control
switch operation.
. Check wheel alignment, if necessary (see page
1 8 - 4 ) .
. D o t h e e n g i n e c o n t r o l m o d u l e ( E C M ) i d l e l e a r n
p r o c e d u r e { s e e p a g e ' 1 1 - 1 3 9 ) .
17-10
and Installation (cont'd)
{