Honda Civic Service Manual page 346

ECM ldle Learn Procedure
The idle learn procedure must be done so the ECM can
learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of
these actions:
. Disconnect the battery.
Replace the ECM or disconnect its connector.
Reset the ECM.
NOTE: Erasing DTCS with the Honda PGM Tester
does not require you to do the idle learn procedure.
Remove the No.6 ECU {ECM) ( 15A) fuse from the
under-hood fuse/relay box.
Remove the No.19 baftery (80A) fuse from the under-
hood fuse/relay box.
R e m o v e P G M - F I m a i n r e l a y 1 .
Remove any of the wires from the under-hood fuse/
retay Dox.
Disconnect any of the connectors from the under
hood fuse/relay box.
Disconnect the connector between the engine
compartment wire harness and ECM wire harness.
Disconnect the G2 terminal from the transmission
h o u s r n g .
Disconnectthe G'l terminal from the body.
D i s c o n n e c t t h e G 1 0 1 t e r m i n a l f r o m t h e c y l i n d e r h e a d
cover.
Procedure:
To complete the idle learn procedure, do this:
1. Make sure all electrical items (Ay'C, audio, rear
defogger, l:ghts, etc.,) are off.
2. Start the engine, and hold it at 3,000 rpm with no
l o a d { i n n e u t r a l ) u n t i l t h e r a d i a t o r f a n c o m e s o n , o r
u n t i l t h e e n g i n e c o o l a n t t e m p e r a t u r e r e a c h e s 1 9 4 " F
(90'c).
3. Let the engine idle for about 5 minutes with the
throttle fully closed.
NOTE: lf the radiator fan comes on, do not include its
r u n n i n g t i m e i n t h e 5 m i n u t e s .
1 1 - 1 3 9