Blower Unit Removal And Lnstallation - Honda Civic Service Manual

Dust and Pollen Filter Replacement
The dust and pollen filters should be replaced every
3 0 , 0 0 0 m i l e s ( 4 8 . 0 0 0 k m ) o r 2 4 m o n t h s w h i c h e v e r
comes first. Replace the filters more often if the air flow
i s l e s s t h a n u s u a l .
1. Open the glove box. Remove both glove box stops,
then let the glove box hang down (see page 20 63).
2 . R e m o v e t h e f i l t e r l i d ( A ) f r o m t h e b l o w e r u n i t , t h e n
p u l l o u t t h e f i r s t d u s t a n d p o l l e n f i l t e r ( B ) . S l i d e t h e
second filter to the left, and pull it out.
Remove the filter {A) from the housing (B), and
replace the filter.
4. Install the filters in the reverse order of removal.
Blower Unit Removal and
lnstallation
For some models: SRS components are located in this
area. Review the SRS component locations (see page
23-13) and precautions and procedures (see page 23-14)
in the SRS section before performing repairs or service.
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the preset
buttons.
2. Disconnect the battery negative cable, and wait 3
minutes before beginning worK.
3. Remove the right kick panel (see page 20-50),
passenger's dashboard lower cover, and the glove
box {see page 20-63).
4. Cut the plastic cross brace in the glove box opening
with diagonal cutters in the area shown. Remove
and discard the plastic cross brace,
Cut heare.
{cont'd)
21-39