Honda Civic Service Manual page 835

Body Electrical
General Troubleshooting Information (cont'd)
Check for loose retainer (A) and rubber seals (B).
The backs of some connectors are packed with
dielectric grease. Add grease if necessary. lf the
grease is contaminated, replace it.
lnsert the connector all the way and make sure it is
securelv locked.
Position wires so that the open end of the cover faces
oown.
22-4
Handling Wires and Harnesses
. Secure wires and wire harnesses to lhe frame with
their respective wire ties at the designated locations.
. Remove clips carefully; don't damage their locks (A).
S l i p p l i e r s ( A ) u n d e r t h e c l i p b a s e a n d t h r o u g h t h e
hole at an angle, then squeeze the expansion tabs to
r e l e a s e t h e c l i p .
After installing harness clips, make sure the harness
doesn't interfere with any moving pans.
Keep wire harnesses away from exhaust pipes and
other hot parts, from sharp edges of brackets and
holes, and from exposed screws and bolts.
Seat grommets in their grooves properly {A). Do not
leave grommets distorted (B).
l t " /
w l /
\--------\
tfl r'---'..-
I t
J
| , f
. ./
. l l t /
----E;
F. 'l/
I