Honda Civic Service Manual page 541

EPS Components
(
Motor RemovaUlnstallation
(cont'dl
lnsiallation
7. Clean the mating surface of the motor (A) and
gearbox.
Apply a thin coat of silicone grease (P/N 08733-
8070E)to the new O-ring (B), and carefully fit it on
the motor.
Apply grease {Nippon Grease WR-S or equivalent
steering gear grease) into the motor shaft (C).
q
E
8 x '1.25 mm
20 N.m
12.0 kgt.m,7 .2lbl ftl
L==-
c].E@
9 .
17- 5 0
r 0 .
Install the motor on the gearbox by engaging the
motor shaft and worm shaft (D). Note the motor
installation position {direction of motor wires).
Before tightening the bolts, turn the motor two or
three times right and left about 45 degrees. lvlake
sure the motor is evenly seated on the steering
gearbox and that the O-ring is not pinched betlveen
the mating surfaces.
Installthe removed Darts in the reverse order of
removal. and note these items:
lvlake sure the motor 2P connector is properly
connected.
lvlake sure the motor and EPS wires are not
caught or pinched by any parts.
Reconnect the negative cable to the battery.
D o t h e e n g i n e c o n t r o l m o d u l e ( E C M ) i d l e l e a r n
p r o c e d u r e ( s e e p a g e 1 1 - 1 3 9 ) .
Enter the anti-theft code for the radio station
Dresets. Reset the clock,
Do the oower window control unit reset
procedure (see page 22-1241.
After installation, start the engine, and let it idle.
Turn the steering wheel from lock-to-lock several
times. Check that the EPS indicator does not come
o n .
1 1 .
1 2 .
1 3 .