Power Mirrors
Power Mirror Actuator Replacement
Remove the power mirror (see page 20-15).
Carefully remove the mirror holder from the mirror
h o u s i n g . G e n t l y p u l l i t o u t b y h a n d ( s e e p a g e 2 0 - 1 5 ) .
Disconnect the connector.
Remove the cover, then remove the two Torx
screws from the mirror connector.
Record the terminal locations and wire colors.
Cut the wire harness with the wire cutter.
7. Remove the three screws, and separate the mirror
housinq from the mirror base.
' 1 .
2 .
3 .
4 .
5 .
6 .
22-118
J
\
4
8. Remove the three Torx screws, and separate lhe
actuator (A) from the mirror housing {B).
Route the wire harness {A) ofthe new actuator
t h r o u g h t h e h o l e i n t h e b r a c k e t ( B ) .
9 .
\
J