Door Glass And Regulator Replacement - Honda Civic Service Manual

Door Glass and Regulator Replacement
NOTE: Put on gloves to protect your hands.
1. Remove these items:
. Door panel (see page 20-4)
. Plastic cover. as necessary (see page 20-2)
2 . C a r e f u l l y r a i s e t h e g l a s s ( A ) u n t i l y o u c a n s e e t h e
bolts, then remove them. Carefully pull the glass
out through the window slot. Take care not to drop
the glass inside the door.
Fastener Locations
) : B o h , 2
@
6 x 1 . 0 m m
9.8 N m {1.0 kgl.m, 7.2 lbf.ftl
3. Disconnect and detach the connector (A) and
h a r n e s s c l i p ( B ) f r o m t h e d o o r .
Fastonor Locations
C > : B o l t . 1 D > : B o l t , 5
6 x 1 . 0 m m
8 N.m
(0.8 kgf.m,
6 rbf.ftl
Remove the bolts (C), and loosen the bolts (D), then
remove the regulator (E) through the hole in the
door,
Apply multipurpose grease to all the sliding
surfaces of the regulator (A) where shown.
Installthe glass and regulator in the reverse order
of removal, and note these items:
. R o l l t h e g l a s s u p a n d d o w n t o s e e i f i t m o v e s
freely without binding.
. Make sure that there is no clearance between the
g l a s s a n d g l a s s r u n c h a n n e l w h e n t h e g l a s s i s
ctoseo.
. Adjust the position of the glass as necessary (see
p a g e 2 0 - 1 1 ) .
. Check for water leaks (see step 7 on page 20-121.
. Test-drive and check for wind noise and rattles.
. W h e n r e i n s t a l l i n g t h e d o o r p a n e l , m a k e s u r e t h e
plastic cover is installed properly and sealed
around its perimeter.
20-9