Preparing The Memory Modules; Preliminary Steps; Preparing A Memory Module; Concluding Steps - Fujitsu PRIMERGY CX2550 M2 Upgrade And Maintenance Manual

Liquid cooling

10.2.2 Preparing the memory modules

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

10.2.2.1 Preliminary steps

"Disabling SVOM boot watchdog functionality" on page 54
Ê
"Shutting down the server node" on page 39
Ê
Ê Disconnect the tubes from the tube system of the rack as described in the
TM
"RackCDU
"Removing the server node from the server enclosure" on page 40
Ê
"Removing the liquid cooling kit" on page 189
Ê
"Removing memory modules" on page 124
Ê

10.2.2.2 Preparing a memory module

Figure 101: Prepared memory module
Ê Stick the cooling pad(s) on one or two sides of the memory modules, see
"Adhesive rules for the memory cooling pads" on page

10.2.2.3 Concluding steps

I
Before powering on the server node connect the tubes to the tube
system of the rack as described in the "RackCDU
202
Service Manual"".
Upgrade and Maintenance Manual
Hardware: 15 minutes
Software: 5 minutes
200.
TM
Service Manual".
CX2550 M2