Important Notes On Preparing Your Device For Use Via The Power Over Ethernet Module; Transporting The Device - Fujitsu FUTRO S940 Operating Manual

Important notes
Important notes on preparing your device for use
via the Power over Ethernet module
Using the Power over Ethernet module, you can operate the device via the LAN without an
additional power connection. You will need a suitable network infrastructure for this.
To operate the device via the Power over Ethernet module, midspan devices conforming
to IEEE 802.3at and shielded CAT 5 network cable or higher quality cable are required.
Endspan devices will only be supported in conjunction with a hardware classification.
Fujitsu recommends the use of the following midspan devices:
• 1 port midspan from Microsemi PD-9501G: S26361-F1744-L10
• 12 port midspan from Microsemi PD-9512G: S26361-F1744-L20
Not all hardware configuration levels are possible while operating the device
via the Power over Ethernet module because of the limited power output. The
following hardware configurations are possible:
Internal memory expansion
M.2 SATA module
SmartCard reader
Speaker
WLAN
PCI/PCIe cards or extra interfaces
Depending on the system utilisations, occupancy of external interfaces (excluding the keyboard,
screen, microphone and headset) may cause overloading of the Power over Ethernet module.
In order to support the largest possible occupancy of interfaces, if an overload occurs the
performance of the system is lowered by a reduction in the CPU frequency. If the CPU frequency
is permanently reduced, the occupancy of the external interfaces must be checked and reduced
accordingly to prevent damage to the Power over Ethernet module or the midspan. Alternatively,
the system can also be connected via a suitable AC adapter (see note in this Operating
Manual). The system must be switched off before the AC adapter is connected.
If you are perhaps retrofitting the device with a Power over Ethernet module, please
pay attention to the maximum possible expansion. If PCI/PCIe expansion cards are
installed, these must be removed, otherwise the Power over Ethernet module or the
midspan may be overloaded and switched off automatically.

Transporting the device

Device, Transportation Retransportation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
12
according to Configurator
according to Configurator
internal SmartCard reader
internal speaker
internal WLAN module according to Configurator
none
Fujitsu