Upgrading To 8X 3.5-Inch Hdd Configuration; Preliminary Steps; Installing The Second 3.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) and solid state drive (SSD)
7.4.8

Upgrading to 8x 3.5-inch HDD configuration

Upgrade and Repair Unit
(URU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
7.4.8.1

Preliminary steps

"Suspending BitLocker functionality" on page 67
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the power cord" on page 49
Ê
"Getting access to the component" on page 50
Ê
"Removing the air duct" on page 61
Ê
"Removing the fan holder" on page 63
Ê
7.4.8.2

Installing the second 3.5-inch HDD backplane

Ê Install the second backplane, see section
backplane" on page
Ê Connect the second backplane, see section
backplane" on page
Ê Connect the power cable from the second backplane to connector PWR2 on
the system board.
Ê If applicable, install a dual-channel RAID controller, see section
expansion card" on page
Ê Connect the SAS cable to the system board or the corresponding controller.
I
For the cable plan, see chapter
174
171.
173.
208.
"Appendix B" on page
Upgrade and Maintenance Manual
Hardware: 10 minutes
"Installing a 3.5-inch HDD
"Connecting a 3.5-inch HDD
411.
"Installing an
RX2520 M4