Show Vrrp - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
130 Confidential and Proprietary Information of ZTE CORPORATION
Field
Track 1
Interface
Line-protocol
Change
Last change
Track by
Vrrp fei_1/1 1

show vrrp

Use this command to display the configuration information of all
VRRP groups.
Privileged EXEC
show vrrp [<group>| brief | interface <interface-name>| all]
<group>
brief
interface <interface-
name>
all
By default, the show vrrp command shows the configurations of
all active VRRP groups.
This example describes how to configure A VRRP group is config-
ured on the vlan1 interface.
ZXR10#show vrrp
Vlan1 - Group 1
State is Master
Virtual IP address is 10.1.1.1
Virtual MAC address is 0000.5e00.0101
Advertisement interval is
Preemption is enabled
min delay is 0.000 sec
Priority is 255 (config 100)
Authentication is disabled
Track object 1 decrement 30
Master Router is 10.1.1.1 (local), priority is 255
Master Advertisement interval is
Master Down interval is
The displayed information descriptions are shown below.
Description
Track ID
Interface traced by the track
Interface link status: up/down
Change times of the interface link's status
Last change time of interface status
What modules are configured to be traced
by the track
Tracked by VRRP group 1 on the fei_1/1
Virtual router ID, 0 ~ 255.
Brief information configured for the VRRP
Name of the interface
Displays configuration information of all VRRP
groups (including the group without virtual
address)
1.000 sec
1.000 sec
3.003 sec