Vrrp Advertise - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
132 Confidential and Proprietary Information of ZTE CORPORATION
<group_no>
line-protocol
interface
� Track is used to track the up/down status, BFD link status and
PING detection status of the interface. When the status of the
interface changes, related module is triggered to process the
change.
� The platform version 4.6.03 and upgrade versions support this
command.
This example describes how to track the status of the fei_1/1 in-
terface.
ZZXR10#conf t
ZXR10(config)#track 1 interface fei_1/1
ZXR10(config-if)#
show track

vrrp advertise

Use this command to set the time interval for sending VRRP adver-
tisement on the interface. Restore the default with the no com-
mand.
Interface configuration
vrrp <group> advertise [msec]<interval>
no vrrp <group> advertise
<group>
msec
<interval>
VRRP enables advertisement interval of less than one second.
However, in encapsulating packets, the advertisement time shall
be one second. In this way, the time learned by the other end will
still one second, and the configuration of less than one second
will not be learned.
This example describes how to configure the time interval for send-
ing VRRP advertisement on the interface as 2 seconds.
ZXR10(config)#interface vlan 1
ZXR10(config-if)#vrrp 1 advertise 2
Automatic detection number
Status of the tracked interface
Virtual router ID, 0 ~ 255.
Change the unit of the time from second into
minute
Interval for the master to send VRRP
advertisements. In the unit of second, 1 ~
255; in the unit of milliseconds, 100 ~25000.
1 second by default