Renew Dhcp; Show Ip Dhcp Configure - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Syntax
Description
Instruction
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instruction
Example
Related
Commands
Purpose
Command Modes
Syntax
108 Confidential and Proprietary Information of ZTE CORPORATION
<interface>
The input interface name should be the enabled dhcp client inter-
face. If the interface already obtains the IP address, then the IP
address will be released after executing this command.
The platform 4.8.22 version supports this command.
It is only applied to 59 series switches currently.
This example shows how to release the IP address that interface
VLAN1 obtained.
ZXR10#release dhcp vlan1
ZXR10#

renew dhcp

renew dhcp

Use this command to release the IP address that the specified in-
terface obtains.
Privileged EXEC
renew dhcp <interface>
<interface>
The input interface name should be the enabled dhcp client inter-
face. If the interface already obtains the IP address, then the dhcp
request flow will be launched again after executing this command.
The platform 4.8.22 version supports this command.
It is only applied to 59 series switches currently.
This example shows how to renew the IP address that interface
VLAN1 obtained.
ZXR10#renew dhcp vlan1
ZXR10#
release dhcp

show ip dhcp configure

Use this command to display DHCP process configuration related
parameter.
Privileged EXEC

show ip dhcp configure

The layer-3 interface name, such as fei_1/1,
vlan1.
The layer-3 interface name, such as fei_1/1,
vlan1.