Flag S1S0; Flowcontrol - Zte ZXR10 8900 Series Command Reference Manual

Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Default POS/ATM SDH is 0x01, SONET is 0xcc and this command
is used for POS interface and ATM interface.
This example shows how to set POS port section trace sign field
J0.
ZXR10(config)#int pos48_1/1
ZXR10(config-if)#flag ?
c2 Path overhead byte
j0 Section trace byte
s1s0 Specify bit S1 and S0 of H1
ZXR10(config-if)#flag j0 ? <0-255> Byte value
ZXR10(config-if)#flag j0 2

flag s1s0

Use this command to set POS port and ATM port section trace sign
field S1. Restore the system default configuration(0x24) of POS
port synchronization state field S1.
Interface configuration
flag s1s0 <value>
no pos flag s1s0 <value>
<value>
Default POS/ATM are 2.
This command is used for POS interface and ATM interface.
This example shows how to set POS port section trace sign field
S1.
ZXR10(config)#int pos48_1/1
ZXR10(config-if)#flag ?
c2 Path overhead byte
j0 Section trace byte
s1s0 Specify bit S1 and S0 of H1
ZXR10(config-if)#flag s1s0 3

flowcontrol

Use this command to configure flow control on an Ethernet port.
Restore default with the no command.
Interface configuration
flowcontrol {enable | disable}
no flowcontrol
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
in the range of 0~3
25