Dte Enable; Duplex - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example

dte enable

Use this command to set the working mode of synchronous serial
port to DTE.
Interface configuration

dte enable

DTE working mode
It is only applied to ZXR10GAR, ZXR ZSR.
This example describes how to set the working mode of serial port
serial_1/1 to DTE.
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#dte enable

duplex

Use this command to configure the working mode of the 100M
interface as the half duplex mode and full duplex mode. Restore
default with the no command.
Interface configuration
duplex {half | full}
no duplex
half
full
Full duplex mode
Fast Ethernet electrical interface and gigabit Ethernet electrical in-
terface supports both half and full duplex modes. The fast Ether-
net optical interface, gigabit Ethernet electrical interface and 10 G
Ethernet interface support the full duplex mode only.
This example describes how to configure the interface fei_1/1 as
the full-duplex mode.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#duplex full
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Configures the working mode of 100 M port
as half duplex mode
Configures the working mode of 100 M port
as full duplex mode
19