Reference Clock - Zte ZXR10 8900 Series Command Reference Manual

qinq range internal-vlan <1-4094> external-vlan <1-4094>
qinq range internal-vlan 1-3 external-vlan 4-9
Only one segment of tags can be configured on high end routers.
For switches:
qinq range internal-vlan <1-4094> external-vlan <1-4094
Syntax
internal-vlan
Description
external-vlan
Instruction �
�
�
�
�
Example �
�

reference clock

Purpose Use this command to set the clock source of the SMP board. Re-
store the default with the no command.
Command Modes Global configuration
Syntax
reference clock {bits | local | port <interface-name>}
no reference clock
Syntax
bits
Description
local
port <interface-na
me>
Defaults The default is local.
Tag of internal VLAN
Tag of external VLAN
Only one segment of tags can be configured on high end
routers. Up to 10 segments of tags can be configured on
switches.
It is applied to Ethernet interface and qinq interface.
The internal tag and external tag can not be overlapping on the
sub interface of the same physical interface at the same time.
This command can not be configured together with qinq com-
mand, encapsulation dot1Q range command and encapsu
lation dot1Q command.
The range of internal tag and external tag should be within
1000 for once configuration.
This example shows how to configure the tags of internal VLAN
and external VLAN on a high end router.
ZXR10(config-if)# qinq range internal-vlan 1-3 external-vlan 4-9
This example shows how to configure the tags of internal VLAN
and external VLAN on a switch.
ZXR10(config-if)# qinq range internal-vlan 1-3,5-10,12-32 external-vlan 6-9,12-46
Uses the bits clock as the clock source.
Uses the local oscillator of the SMP as the
clock source.
Interface name, and no subinterface is
supported.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
45