Vrrp Mode; Vrrp Out-Interface - Zte ZXR10 8900 Series Command Reference Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
show vrrp

vrrp mode

Use this command to configure the mode of virtual device. There
are two modes: standard and private. The units of advertisement
time in the VRRP protocol message are different in the two modes.
Interface configuration
vrrp <group> mode {standard | private}
no vrrp <group> mode
<group>
{standard | private}
Standard mode
The unit of advertisement time in the VRRP protocol message in
standard mode is 1s. The unit of advertisement time in the VRRP
protocol message in private mode is 100ms.
This example shows how to configure the mode to private.
ZXR10(config)#interface vlan 1
ZXR10(config-if)#vrrp 1 mode private
show vrrp

vrrp out-interface

Use this command to set the out-interface for sending VRRP pro-
tocol message. Restore the default with the no command.
Interface configuration
vrrp <group> out-interface <interface-name>
no vrrp <group> out-interface
<group>
<interface-name>
Set the interface in which the VRRP group shall send the packet.
When interface does not match the VRRP group, the message will
be sent from the interface which sets VRRP group by default.
This example describes how to set VRRP out-interface.
ZXR10(config)#interface vlan 1
ZXR10(config-if)#vrrp 1 out-interface vlan 2
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 6 VRRP Configuration
Virtual router ID, 1 ~ 255
Standard mode or private mode
Virtual router ID, 1 ~ 255
Name of out-interface
135