Change-Attribute Copper - Zte ZXR10 8900 Series Command Reference Manual

Instructions This command only supports shielding the link up/link down alarm
information of the interface and SNMP TRAP information under the
following interfaces: the layer-2 fei, layer-2 gei, loopback, QinQ,
SuperVlan, SuperQinQ, VLAN, Tunnel, PortCh(SmartGroup).
Example This example describes how to shield the link down alarm and
SNMP TRAP information of interface fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#cancel down-alarm
Related snmp-server host
Commands
snmp-server enable
logging trap-enable

change-attribute copper

Purpose
Use this command to configure a gigabit optical port to support
1000Base_T SFP module. Through this configuration, the port can
support 1000M, 100M and 10M automatic negotiation.
Command Mode Interface configuration mode
Syntax

change-attribute copper

no change-attribute
Instructions 1000Base_T SFP modules can be plugged into gigabit SFP ports on
S2 boards. Through configuration, the ports can support 1000M,
100M and 10M automatic negotiation. At present, the following
boards support this function:
�
�
�
�
�
�
�
�
�
�
�
�
Example
This example describes how to configure the port gei_1/2 to sup-
port the 1000Base_T SFP module.
ZXR10(config-gei_1/2)# change-attribute copper
RS-69S1-24GE-SFP
RS-69S1-48GE-SFP
RS-69S2-48GE-SFP
RS-69S2-24GE-SFP
RS-XGS1-24GE-SFP
RS-XGS1-48GE-SFP
RS-89S1-24GE-SFP
RS-89S1-48GE-SFP
RS-89S2-24GE-SFP
RS-89S2-48GE-SFP
RS-XGS2-48GE-SFP
RS-XGS2-24GE-SFP
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
13