Tug-2 E1 Channel-Group Timeslots - Zte ZXR10 8900 Series Command Reference Manual

Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
SF threshold is 4 by default.
SD (10 bervalue) threshold should be shorter than SF (10
bervalue).
It is applied to POS and ATM interface.
This example describes how to set the failure signal BER threshold
as 3.
ZXR10(config)#int pos48_1/1
ZXR10(config-if)#threshold sf
ZXR10(config-if)#threshold sf-ber ?
<3-9> Sf-ber value
ZXR10(config-if)#threshold sf-ber 3
tug-2 e1 channel-group
timeslots
Create an E1 channel when the CPOS3 interface is set to the SDH
mode, and the AUG is in the AU-4 mapping mode. Delete an E1
channel with the no command.
Channel configuration
tug-2 <tug-2-number> e1 <line> channel-group <channel-nu
mber> timeslots <timeslots>
no tug-2 <tug-2-number> e1 <line> channel-group <channel
-number>
tug-2 <tug-2-numb
er>
e1 <line>
channel-group
<channel-number>
timeslots <timeslo
ts>
It is applied only to ZXR10 GER.
This example describes how to create an E1 channel.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#aug mapping au-4
ZXR10(config-control)#au-4 1 tug-3 1
ZXR10(config-control)#tug-2 1 e1 1 channel-group 1 timeslots 1-31
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
TUG-2 number, ranging 1–7
E1 number, ranging 1–3
E1 channel number, 1 only
Time slot number. Timeslots 1–31 must be
assigned to a channel at one time.
67