Aug Mapping; Baudrate - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
10 Confidential and Proprietary Information of ZTE CORPORATION
<au-4-number>
<tug-3-number>
It is only applied to ZXR10 GER.
This example describes how to enter the configuration mode of
No.1 tug-3.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#aug mapping au-4
ZXR10(config-control)#au-4 1 tug-3 1

aug mapping

au-3

aug mapping

When the cpos3 interface is configured to sdh mode, configure aug
mapping mode with the aug mapping command, and delete all
the interfaces created in the specified mapping mode with the no
command.
Channelization configuration
aug mapping {au-3 | au-4}
no aug mapping {au-3 | au-4}
au-3
au-4
It is only applied to ZXR10 GER.
This example describes how to map the aug to au-3 mode.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#aug mapping au-3
au-3
au-4 tug-3

baudrate

Use this command to set the baud rate of serial port. Restore
default with the no command.
Interface configuration
The value of au-4 must be 1
The value range of tug-3 is 1~3
The aug is mapped to au-3 mode
The aug is mapped to au-4 mode