Clock Source(Cpos48); Controller; Crc - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Example
Purpose
Command Modes
Syntax

clock source(CPOS48)

Use this command to configure the clock extraction mode of the
interface in local router. Restore default with the no command.
Channelization configuration and interface configuration
clock source {system | line | free-run}
no clock source
system
line
free-run
The clock mode is system.
This command runs in the controller configuration mode..
This example shows how to configure the clock extraction mode
on CPOS48 interface.
ZXR10(config)#controller cos48_1/1
ZXR10(config-control)#clock source line

controller

Use this command to enter CE1, CT1, CE3 or CPOS3 channelization
configuration mode.
Global configuration
controller <interface-name>
<interface-name>
This example describes how to enter CE1 channelization configu-
ration mode.
ZXR10(config)#controller ce1_3/1
ZXR10(config-control)#

crc

Use this command to set the crc mode of synchronous serial port
or pos port.
Interface configuration

crc {16 | 32}

Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
System clock
Line clock
Uses the local clock as the clock source
Interface name
17